![]() ![]() Interacts seamlessly with “Tool-Pro Controlled Bolting” software to provide bolting calculations and data for : (Hydrostatic, Pneumatic, Nitrogen or Helium) Integrity Pro joint integrity database management system is used to support bolted joint inspection and maintenance and/or leak testing activities raising safety levels across the industry in which it applies.įull traceability and control of all activitiesĪssociated with the joint/connection including: It also includes basic information for standard flanges, wafer check valves, spade and spacers, and swivel flange assemblies. Integrity-Pro can also create a specific tightening procedure for each bolted joint, which can include specific information such as any special remarks all of which can be easily entered into the software by the user. Based on the information entered, the Integrity-Pro software will analyse all of the data and produce a complete calculation sheet along with the required torque or tension figures to ensure an accurate and correctly bolted joint is achieved. Offering data gathered from years of industry experience, Integrity Pro can provide bolt tightening data including bolting patterns, torque and tensioning figures, procedures, techniques and recommended controlled bolting equipment. It has been adopted by major plant operators as an essential management system due to it’s simplicity and comprehensive covering of the plant and related maintenance. This database system interacts with the “Tool-Pro Controlled Bolting Software” calculation engine, runs on the standard Windows operating system and does not require the use of third party database servers. When a fire door has been deemed as non-compliant following our inspection or the fire risk assessment then we are suitably certified to carry out replacements.INTEGRITY-PRO Joint Monitoring software is a bespoke database system specifically developed to plan, monitor, control and provide traceability of flanged joints and connections. The report also includes a full list of any remedial actions needed to bring the doors up to the necessary standard. ![]() This guidance advises that fire doors, and all supporting components, should be checked periodically as determined by the building’s fire risk assessment.įollowing the fire door inspection you will be provided with a detailed report which highlights the pass/fail rating for each door based on required criteria. This will be confirmed in your fire risk assessment and is a requirement under the Regulatory Reform (Fire Safety Order) 2005. To make sure they function correctly in the event of a fire, they must be regularly inspected, tested and maintained. They are essential in all buildings and are a key element of the fire safety strategy. They impede the passage of smoke, toxic fumes and fire along with compartmentalising a building to maintain a safe means of escape for its occupants. Similarly to firestopping, fire doors are a critical part of your building’s passive fire protection system. We’ll also check intumescent seals, smoke seals, hinge condition, signage, door closers, fire rated glass, locks, latches, handles. The comprehensive assessment will involve checking there is no obvious damage that may affect the integrity of the door or the gap around the door frame, and that the threshold is within permissible tolerance. We are fully qualified to carry out the audit/check/inspection of your fire doors and will subsequently prepare a detailed report on the fire doors on your premises. PFS offers a professional and expert fire door inspection service that is independent. ![]()
0 Comments
Leave a Reply. |